Controller for KITs with LED3, LCD5 or LCD5 PLUS display This is a controller without hall sensors. It can power any Platinium engine without or a damaged HAL sensor, at the cost of a slightly rougher start. 9-pin connector, but only 6 have continuity
Controller HIC for kits with LED3, LCD5 or LCD5 PLUS display
- Rated / maximum amperes: 11/22
- Phase: 120º
- Voltage: 36 v.
- Measure:
- Weight:
- Waterproof connections.
- Holder includes
- Just for use with a FT type battery
Connections:
- Handlebar bus cable
- Pas Sensor
- Battery
- Motor
- Lights (1 amp)
